Cover Image

Application of Chemically Modified Industrial Slag to As(III) Adsorption from Wastewater: Kinetics and Mass Transfer Analysis

Arijit Dutta Gupta, Vivek Jaiswal, Vivek Bhadauria, Harinder Singh

Abstract


In the present study, brick kiln slag (BKS) has been utilized for low concentration As(III) adsorption in batch mode. BKS was modified with H2SO4 (SA) and NaOH (SB) for enhancing As(III) uptake capacity. Maximum adsorption capacity (13.7 mg/g) was observed for SA at 298 K, pH = 7.0, adsorbent dose = 0.3 g and time = 70 min which was 1.4 times higher than that of SB. Adsorption data modelled into Freundlich isotherm and pseudo-second-order kinetics. Mass transfer coefficients decreased with increase in As(III) concentration. Film diffusion significantly dominated the adsorption of As(III) ions irrespective of the initial concentration. Dimensionless Sherwood number (Sh) interrelated As(III) concentration (Co) as: Sh = 2.97(Co)–0.376, Sh = 4.12(Co)–0.215, Sh = 4.83(Co)–0.588 for H2SO4 modified, NaOH modified and native slag respectively. Low temperature (298 K) favoured As(III) adsorption (based on ∆G° value). Therefore, the modified slag can be used as an effective adsorbent for As(III) remediation from groundwater.


Keywords


As(III) adsorption; Industrial slag; Mass Transfer; Film diffusion; Sherwood number

Full Text:

PDF


DOI: http://dx.doi.org/10.17344/acsi.2020.6283

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Arijit Dutta Gupta, Vivek Jaiswal, Vivek Bhadauria, Harinder Singh

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.